Silicon Optix 50HD - Manual (Page 12)

Chapter 1 – Introduction
3
I
NTR
O
DUCTION
Components
Front View
Remote Control: Enables you to control the projector. There are infrared sensors on
the front and rear of the projector allowing you to control the color temperature, input
device, gamma correction, OSD menu items, and turn the projector on and off. You
can also connect the remote control to the Wire Remote Control jack on the back
panel. See "Wired Remote Control" on page 11.
Control Panel: The control panel enables you to adjust the focus and zoom of the
projector lens, set the input device, gamma, and color temperature, access the OSD
menus, and turn the projector on and off.
Remote Control Sensor: Point the remote control at this sensor to operate the pro-
jector with the remote control. There is another sensor at the rear of the projector.
Lens Cap: The lens cap protects the projector lens when the projector is not in use.
Ventilation: The projector has a strong fan to keep the lamp from becoming too hot.
Adjustment Peg: The adjusment peg enables you to adjust the image height.
Note: Ensure that the ventilation slots have enough space around them
for proper air flow.
Warning!
Because the projector lamp becomes extremely hot, air coming
from the ventilation slots can be uncomfortably hot.
Remote
Control
Ventilation
Lens Cap
Remote
Control
Sensor
Control
Panel
Adjustment
Peg