Turning off, Onnections – Silicon Optix 50HD User Manual
Page 22
Chapter 2 – Connections
13
C
ONNECTIONS
Turning Off
Warning!
Follow these procedures exactly as written to avoid damage to the
lamp and projector.
1. Press the power button on the control panel or remote to open the
Power Down Menu. Select Yes and and press Enter. Alternately, you
can press the power button three times.
2. The lamp shuts off and the cooling fans continue to run for approxi-
mately two minutes to cool-down the lamp. During this cool-down
period, the control panel LEDs flash.
3. After the fans shut off and the control panel LEDs stop flashing, the
projector is in standby mode. The projector can be left in this state or
you can set the rear panel power switch to "o" to remove all power
from the projector.
This concludes this chapter. The next chapter describes operation of the projector.