Silicon Optix 50HD - Manual (Page 7)

Preface
NOTICES
Warning! To meet FCC requirements, a shielded power cord is
required in order to prevent interference. It is essential that only the
supplied power cord be used. Use only shielded cables to connect
I/O devices to this equipment. You are cautioned that changes or
modifications not approved by the party responsible for compliance
could void your authority to operate the equipment.
Warning! The projector cooling fan continues to run for approxi-
mately two minutes after the projector is turned off using the Power
button on the control panel or remote control. Never turn off the
projector using the power switch on the projector while the lamp is
lit. This can damage the lamp or power supply.
Warning! High brightness light source. Do not stare into the beam
of light, or view directly. Do not allow children to stare directly into
the beam of light.
Warning! To reduce the risk of fire or electric shock, do not expose
this product to rain or moisture.
Caution!
For minimal servicing and to maintain high image quality, we rec-
ommend that you use the projector in an environment that is smoke
and dust free. When used in areas where there is a lot of smoke or
dust, the filter and lens should be cleaned often to lengthen the ser-
vice life of the projector.
Warning! The ventilation slots, lamp, and objects next to them may
get extremely hot during operation. Do not touch these areas until
they have sufficiently cooled down.
Warning! When replacing the lamp, turn off the power switch and
disconnect the input power. Allow the lamp to cool at least 15 min-
utes prior to opening the lamp door.