Sony RM-AV3100 - Manual (Page 26)

26
Using Non-Preset Remote Control
Operations
— Learning Function (continued)
Changing or erasing the
function of a taught key or
button
To change the learned function, clear it
first and perform learning again.
To clear the learned function of a
single key or button
1
After Step 4 (page 21), while
pressing the DEL key, press the
key or button you want to erase.
The cleared key flashes together with
other learnable keys.
2
Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previously
set mode.
For accurate learning
• Do not move the remote units during
the learning procedure.
• Be sure to keep holding down the
button of the other remote control until
you hear the confirmation beep.
• Use fresh batteries in both remote
control units.
• Avoid learning in places under direct
sunlight or strong fluorescent light.
• The remote control detector area may
differ depending on each remote unit.
If learning does not work, try changing
the positions of the two remote control
units.
• When you teach signals of an
interactive signal exchange system
remote control unit (supplied with
some of Sony’s receivers and
amplifiers) to the Commander, the
response signal of the main unit may
interfere with the learning of the
Commander. In such a case, move to a
place where the signals will not reach
the main unit (e.g. other rooms, etc.).
IMPORTANT
Be sure to place the Commander out
of the reach of small children or pets.
Also set the Hold function to lock the
all buttons on the Commander (page
76) when it is not used. Components
such as air conditioners, heaters,
electric appliances, and electric
shutters or curtains receiving an
infrared signal can be dangerous if
misused.