Sony RM-AV3100 - Manual (Page 52)

52
5
Press and hold down the button
of the remote control until you
hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
While receiving the signal, “LEARN”
stays lit.
If “NG” flashes on the display and
“NG” sound is heard five times
Learning did not succeed. Try Steps 4 and 5
again.
6
Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previous
setting mode.
Note
You cannot program a remote control signal for
a SYSTEM CONTROL button or a Label key by
“learning” for which the System Control
function have been programmed. If you want to
program a remote control signal for that button,
clear programmed commands first (page 36).
To clear the learned remote
control signal
1 While pressing COMMANDER OFF,
press MUTING.
2 Press the LEARN key.
“LEARN” appears on the Mode
Display key.
3 While pressing the DEL key, press the
SYSTEM CONTROL button or the
Label key of which learned signals are
to be cleared.
The learned signals are cleared.
4 Press COMMANDER OFF.
If you want to program a new signal for
that button, follow Steps 4 to 6 in the left
column.
Programming a Frequently Used
Key Operation for SYSTEM
CONTROL Buttons or Label Keys
(continued)