Sony RM-AV3100 - Manual (Page 68)

68
11
When you have programmed a
series of Timer Macro setting,
press COMMANDER OFF.
COMMANDER
OFF
With a beep sound, a series of Timer
Macro setting is registered and
displayed in order.
When you have programmed the
buttons on the Commander
The names of buttons on the Commander
which are not on the LCD touch key
display (VOLUME +/–, MUTING,
CHANNEL +/–, RECALL, MENU, OK,
EXIT,
, , , and ) are displayed on
the right Label key.
The display returns to Step 3.
If you want to check the execution
of the timer setting or set the
timer program to the standby
mode
See page 70.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The timer setting of the program is decided,
and the Commander turns off. In this case,
the timer program is not set to the standby
mode.
Note
Some programs cannot be executed at the set
time because the execution time of the remote
control output is different depending on the
contents of the timer execution. Or, if the
execution time arrives while the previous timer
program is outputted, the timer program
begins after the execution of the previous one.
In this case also, the program cannot be
executed at the set time. So, set the timer
regarding the contents and the duration of the
timer execution.
To change the program name on
the Mode Display key
After Step 3, hold the Mode Display key
pressed for more than 2 seconds. The
Commander enter the Label Inputting
mode.
Then follow the same procedure as that
for changing the name of the Label key in
Steps 2 - 5 on page 25.
To change the interval between
timer operation steps
See page 41.
Notes
• When using the timer setting on this
Commander, only one setting can be assigned
to one program. If you want to set the timer
to turn on at a programmed time, and to set
the timer to turn off at another time, program
the two settings separately.
• If there are some programs set to be executed
at the same time, they start in order from the
lowest program number.
• According to the status of the component
operated by the timer program, the next
program might not function successfully.
When setting a timer program, check
carefully the setting of other programs.
Setting the Timer (continued)