Sony RM-AV3100 - Manual (Page 61)

61
3
Press the Component Select
button to which you want to
assign the data.
Or press the Label key to which you
want to assign the data. To change the
Label keys, press the OTHER button
repeatedly.
TV
The selected component name
appears on the left Label key.
4
Press the ENTER key.
During receiving the data, “ c c c c”
flashes.
When the data has been successfully
received, the selected component
name appears on the right Label key.
Notes
• If the Commander is not ready for
receiving the data, press the CLEAR key,
then press the RETURN key to clear the
learned signal on all or one of the
Component Select buttons.
• If “NG” appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending Commander
again to send data.
5
Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previous
setting mode.