SATO DR300 - Manual (Page 50)

DR300 Operator Manual
48
4) Media Parameter Transmission
This command designates paper size, base reference position, sensor type, etc. <M>
[1BH, 4DH] n n n…..
E Size Base reference Paper
Vertical
position Horizontal
position E Copy Image Rotate Print
S M Designation
position
designation Information adjustment adjustment J designation designation
C
E
C
T
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Digit Position Item Data Description
1 – 3 Size designation nnn Designates paper size for printing with mm unit.
4 Base reference position
(Direction) n Shows moving direction of base position for print and
cut.
1 : + towards feeding direction
0 : - towards feeding direction
5 – 7 Base reference position
designation (Movement) nnn Designates movement of base position for print and cut
in dot unit.
8 Paper Information (Kind
of paper) n Label = 0, Tag = 1
9 Paper Information
(Sensor)
n Centre hole = 1
I-mark = 2 } Designates paper identifying
Gap = 3 } sensor
Side hole = 4 }
10 Paper Information (Cut
function) n Cut function OFF = 0, ON = 1
11 Vertical position
Adjustment (Direction)
+ , - From top of print, DOWN = +, UP = -
12 , 13 Vertical position
Adjustment
(Movement) nn Value in dot unit
14 Horizontal position
Adjustment (Direction)
+ , - From top of print, RIGHT = +, LEFT = -
15 , 16 Horizontal position
Adjustment
(Movement) nn Value in dot unit
17 Eject Cut n Eject function, OFF = 0, ON = 1
18 Image Copy (ON/OFF) n Image print OFF = 0, ON = 1
19 , 20 Image Copy
(Movement) nn Designates sideway movement in mm unit
21 Rotate print (ON/OFF) n Rotate print OFF = 0, ON = 1
22 , 23 Rotate print
(Paper Width) nn Designates width of paper used in mm unit.
Chapter 9 - Online Programming