Siemens HiPath 4000 - Manual (Page 75)

Description of functions Alphabetical Reference
75
QCU Home Address
• Enter the Æ IP address of the QCU-Server on which the QoS-Data have
to be reported.
• Standard value Æ page 96.
Æ page 54
QCU Standby Address
• Only available when using a second communication platform.
• Enter the Æ IP address of the QCU-Server on which the QoS-Data have
to be reported during emergency mode.
Æ page 54
QDC Server
• Enter the Æ Port-Number for communication with the QDC-Server.
• Standard value Æ page 96.
Æ page 56
QoS L2/L3
• The settings relate to the Æ Layer 2 and Æ Layer 3 areas of the
Æ QoS, that regulate the prioritisation of the transferred data.
• For Layer 2, the Æ VLAN Method and the Æ Default VLAN ID can be
changed. For Layer 3, the Æ L2/L3 Voice/Signalling can be changed.
• The activation of Layer 2 and / or Layer 3 support is meaningful only if
the used
Æ Switch can interpret this information (e.g., "Layer 2
Switch").
• Standard value Æ page 96.
Æ page 23 Æ page 53
QoS Protocol Version
• The Version Number gives information regarding the actuality of the
QoS report file (read only).
Æ page 54
RAM Test
• Here you can test the Æ RAM memory of your optiPoint 410/420.
• The results are displayed after the test is over.
Æ page 26 Æ page 49
Report Interval
• Time interval (in sec.) in reports are sent.
• For each Report Interval a QoS report will be sent if the Æ Report
Mode was set accordingly.
• Valid values: 10 ... 3600.
• Standard value Æ page 96.
Æ page 54