Sennheiser EM500 - Manual (Page 22)

Using the receiver
21
To completely switch the receiver off :
̈
Disconnect the receiver from the mains by unplugging the mains unit
from the wall socket.
The backlighting of the
STANDBY button ¶ goes off.
Monitoring the audio signal via headphones
̈
Set the headphone volume control
·
to the minimum position.
̈
Connect headphones with a ¼” (6.3 mm) stereo jack plug to the head-
phone output
³
.
̈
Gradually increase the volume and monitor the audio signal with the
lowest possible volume.
̈ Keep the STANDBY button ¶ pressed until “ OFF ” appears on
the display panel.
The receiver switches to standby mode.
When in the operating menu, pressing the STANDBY button
¶
will
cancel your entry (ESC function) and return you to the current
standard display.
The STANDBY button
¶
is backlit in red both during operation and
in standby mode.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent
hearing defects.
̈
Set the headphone volume control
·
to the minimum position before
putting the headphones on.
542.625
SKM500
ew500 G3 B.Ch: 20.30
EQ
+ 12dB P
MHz
PEAK
-10
0 40
30
20
10
-20
-40
AF RF
-30
P
³ ·
·