Sennheiser EM500 - Manual (Page 62)

Index
61
LCD Contrast (contrast of the display
panel) 43
Lock mode
activating/deactivating (Auto Lock) 38
deactivating temporarily 23
Locked (lock mode activated) 23
Low Battery (warning message) 43
Low RF Signal (warning message) 43
M
Mains unit, connecting 19
Menu (main menu)
overview 27
settings 34
Mixing console/amplifier, connecting 17
Mounting
antennas 13
rack mount “ears” 12
receiver 12
Multi-channel operation 46
Mute (muting the audio signal) 24
Muting (audio signal) 24
N
Name (entering a name) 37
Network (connecting receivers in a
network) 18, 46
Network configuration, adjusting 44
O
Operating menu, using 29
P
Pilot tone evaluation, activating/
deactivating 42
R
Rack mount “ears”, Mounting 12
Rack mounting
one receiver 14
two receivers 16
Receiver
cleaning 49
connecting ~s in a network 18, 46
mounting into a rack 12
~ parameters (standard display) 10
placing onto a flat surface 12
switching on/off 20
synchronizing with transmitter 22, 45
Receiving Frequency
selecting (Frequency Preset) 39
Receiving frequency
selecting (Frequency Preset) 35
setting (Tune) 39
Reception, optimizing 50
Reset List (releasing all locked frequency
presets) 35
RF (Radio Frequency) 10
RF Mute (warning message) 43
RX Mute (warning message) 43
RX Mute On/Off (muting the audio signal) 24
S
Scan New List (frequency preset scan) 35, 45
Setting up
multi-channel system 46
transmission link 45
Settings
equalizer 38
Guitar Tuner 40
Software Revision (displaying the software
revision) 44
Squelch (adjusting the squelch) 34
Switching on/off (receiver) 20
Sync Settings (submenu)
overview 28
settings 41
Synchronizing (transmitter with receiver) 22,
45
T
Transmission link, setting up 45
Transmitter
adjusting the transmitter parameters
(Sync Settings) 41
synchronizing with receiver 22, 45
Troubleshooting 51
Tune (setting the receiving frequencies and
frequency banks) 39
TX Mute (warning message) 43
U
Unlock (deactivating the lock mode) 23