Sennheiser EM500 User Manual
Page 47
Synchronizing transmitters with receivers
46
Synchronizing transmitters with receivers –
multi-channel operation
Network operation
Combined with ew 500 G3 transmitters, ew 500 G3 receivers can form
transmission links that can be used in multi-channel systems.
In multi-channel operation, the receivers are remote controlled via a PC
running the “
Wireless Systems Manager
” (WSM) software.
For further information on downloading the software, visit the ew G3
product page on our website
̈
Connect the receivers in a network (see page 18).
̈
Launch the “
Wireless Systems Manager
” (WSM) software).
̈
To scan for unused receiving frequencies and to configure the receivers,
proceed as described in the instruction manual of the “
Wireless
Systems Manager
” (WSM) software.
̈
Set the corresponding transmitter to the selected frequency bank and
to the selected channel either by synchronizing the transmitter with
the receiver (see page 22) or by setting the frequency bank and the
channel manually (see the instruction manual of the transmitter).
Your multi-channel system is now set up.
Operation
without network
If you want to set up a multi-channel system without using the WSM,
proceed as follows:
̈
Switch off all transmitters of your system that are to be automatically
configured.
Channels used by switched-on transmitters are displayed as “used”.
In
In order to ensure an intermodulation-free transmission, use the
same frequency bank for all transmission links.
WSM
Advantages of controlling the receivers via the “
Wireless Systems
Manager
” (WSM) software:
• Detailed overview of all receiving channels
• Remote control of all receivers in the network
• Combination of receivers of different frequency ranges