Seiko Group OFL-12 SERIES - Manual (Page 20)

3 - 1
CHAPTER 3
POLISHING PREPARATION
In this chapter, all the preparations prior to starting polishing are explained.
3.1 POLISHING DISK PREPARATION
Step 1 Disconnect the power cord
from the outlet.
Step 2 Apply grease included in the
product to the underside of the
polishing disk. Also apply
grease to the center hole of
the underside.
Step 3 Attach the polishing disk to the
drive coupling, fitting the guide
pins on the drive coupling into
the holes on the underside of
the polishing disk.
NOTE
Make sure the pins on the drive
coupling go into the holes on the
underside of the polishing disk.
NOTE
Do not use the polishing disk
without applying grease to prevent
the machine from being worn out.
Apply grease to the disk before it
dissipates. It is recommended that
you should apply grease once a
month.
Drive coupling
Guide pin
Polishing disk
Grease here
Polishing disk (underside)