Seiko Group OFL-12 SERIES - Manual (Page 31)

4 - 8
Holding jig
Water
Ferrule tip
Soft brush
Step 10 The polishing will automatically
stop when the time set on the
timer is up. After the polishing
is completed, pull the weight
arm lever toward you and
remove the holding jig from the
polishing disk.
NOTE
When removing the holding jig
from the polishing unit, lift the
holding jig up so the ferrules do
not touch the polishing film.
Step 11 Clean the holding jig and the
tips of the ferrules under
running water using the brush.
After cleaning, clean the brush,
removing all polishing grit or
other matter.
This illustration shows running water being used for washing. (There is no problem
if washing is done in the washing container, but using running water is preferred.)
NOTE
After cleaning, remove
waterdrops completely from the
holding jig.
NOTE
Do not touch the operation panel
with wet hands.