Seiko Group OFL-12 SERIES - Manual (Page 34)

4 - 11
NOTE
Make sure that the weight arm
lever goes to the full up position.
If it does not, the correct
polishing pressure will not be
applied to the holding jig and
polishing will not be performed
correctly.
Step 6 Set the timer to 1 min.
(standard).
Preparation for polishing is
complete.
NOTE
The first time a sheet of finishing
polishing film is used, the
polishing fluid will not completely
soak into the polishing film.
Therefore, when using a sheet of
finishing polishing film for the
first time, polish twice (1 minute
each).
Step 7 Press the ON button. The
polishing disk begins to rotate
and polishing begins.
NOTE
Press the OFF button if there is
any problem. The polishing disk
will stop rotating and polishing
will stop.
Step 8 The polishing will automatically
stop when the time set on the
timer is up. After the polishing
is completed, pull the weight
arm lever toward you and
remove the holding jig from the
polishing disk.