Speed Queen Drying Tumblers SCB50EG - Manual (Page 59)

57
M412616
SECTION IV
Preventive Maintenance Instructions
DAILY
1. Make certain drying cycle has ended.
2. Open loading door.
3. Unlock and remove lint panel.
4. Remove accumulated lint in lint compartment.
Lint left in lint compartment will be drawn back
onto lint screen and restrict air circulation.
5. Clean lint from lint screen. If lint screen is torn
replace immediately. A torn lint screen allows lint
to flow into ductwork system restricting air
circulation.
6. Ensure lint screen covers entire opening in lint
screen hood. Gaps between lint screen and lint
screen hood allows lint to flow into ductwork
system restricting air circulation.
7. Wipe any accumulated lint off thermostat
sensing probe. Lint buildup on sensing probe will
cause overheating of tumbler.
8. Replace and securely lock lint panel.
Figure 34
WARNING
T046IE3A
THERMOSTAT
SENSING PROBE
LINT
SCREEN
MONTHLY
1. Perform daily cleaning of accumulated lint.
2. Deactivate electrical circuit by turning off electrical
disconnect switch on rear of tumbler.
4. Remove exhaust duct from rear of tumbler and
clean out all accumulated lint.
5. Reinstall exhaust duct.
6. Remove bottom cover from vertical exhaust duct
and clean out all accumulated lint.
7. Reinstall vertical exhaust duct cover.
8. Inspect entire duct work assembly and clean out
all accumulated lint.
9. Energize electrical circuit to tumbler by turning on
electrical disconnect switch on rear of tumbler.