Sony SAT-HD200 - Manual (Page 26)

25
3. SETUP AND CONNECTIONS
3-4. Connecting to Antennas - Oval Dish (Satellite A, B)
Receiving Signals
1. Connect the “Antenna” to the “ANT IN” jack on the DIRECTV ® High-Definition Receiver using a coaxial
RF cable.
2. Connect the cable TV signal to the “CABLE IN” jack on the DIRECTV HD Receiver using a coaxial RF cable.
3. Connect the “Jack 1” of the multi-switch to the “SATELLITE IN” jack on the DIRECTV HD Receiver using
a coaxial RF cable. (For proper dish installation, refer to the “Installer’s Guide” provided with your satellite
dish antenna.)
4. Connect the “Phone Wall Jack” to “PHONE JACK” on the DIRECTV HD Receiver using a phone cable.
Antenna
LNB
Sat B LNB
Sat A
Dish
Cable TV
wall jack
5x4 Multi-switch
Output
Phone wall jack
NOTE
While you are subscribing to a DIRECTV ®
programming package, you can still view
over-the-air and cable TV programs, if you
make connections to the over-the-air and/or
cable jacks.
NOTE
A triple LNB multi-satellite dish with a SAT
C LNB is required to receive all DIRECTV ®
High-Definition programming, along with
this DIRECTV HD Receiver.