Sony SAT-HD200 - Manual (Page 27)

26
3-4. Connecting to Antennas - Oval Dish (Satellite A, B, C)
Receiving Signals
1. Connect the “Antenna” to the “ANT IN” jack on the DIRECTV ® High-Definition Receiver using a coaxial RF cable.
2. Connect the cable TV signal to the “CABLE IN” jack on the DIRECTV HD Receiver using a coaxial RF cable.
3. Connect the “Jack 1” of the multi-switch to the “SATELLITE IN” jack on the DIRECTV HD Receiver using a
coaxial RF cable. (For proper dish installation, refer to the “Installer’s Guide” provided with your satellite dish
antenna.)
4. Connect the “Phone Wall Jack” to “PHONE JACK” on the DIRECTV HD Receiver using a phone cable.
Phone wall jack
LNB
Sat B LNB
Sat C LNB
Sat A
Dish
Cable TV
wall jack
5x4 Multi-switch
Output
Antenna
NOTE
While you are subscribing to a DIRECTV ®
programming package, you can still view over-
the-air and cable TV programs, if you make
connections to the over-the-air and/or cable
jacks.
NOTE
For access to all DIRECTV ® High-Definition
programming, a triple LNB multi-satellite
dish antenna with a SAT C LNB is required,
along with this DIRECTV HD Receiver and
high-definition television equipment.