Smart Technologies 600i3 User Manual
Page 30
Advertising
18 |
CHAPTER 2 – INSTALLING YOUR SMART BOARD 600I3 OR SBD600I3
INTERACTIVE WHITEBOARD SYSTEM
6. Move the projector forward or backward on the boom to make the image larger
or smaller.
NOTE
During this step, you may need to tilt or turn the projector slightly to keep the
image square.
7. Focus the projector using the focus lever (located on the top of the projector).
NOTE
You may need to repeat all steps in smaller increments in order to fine-tune
the image.
8. Tighten the large wingnut on the top of the ball joint.
Advertising