Connecting the cables to the uf55/uf55w projector, Routing the cables – Smart Technologies 600i3 User Manual
Page 35
23 |
CHAPTER 3 – CONNECTING YOUR SMART BOARD 600I3 OR SBD600I3
INTERACTIVE WHITEBOARD SYSTEM
Connecting the Cables to the
UF55/UF55w Projector
Refer to the following diagrams while you connect the cables to the projector.
Routing the Cables
When connecting cables from the UF55 projector to SMART Board 560, 580, 660, 680
and SBD680 interactive whiteboards, make sure that all cables pass along the top
of your SMART Board interactive whiteboard’s wall-mounting bracket, and then down
the left or right side of your interactive whiteboard.
When connecting cables from the UF55w projector to a SMART Board 685 interactive
whiteboard, make sure that all cables pass between the two SMART Board interactive
whiteboard wall-mounting brackets. The wall-mounting brackets should be spaced at
least four inches apart to provide full support for your interactive whiteboard’s weight.
NOTE
Don’t connect the power cable to a power outlet until you’ve connected all the
cables to the projector.
Cable Routing (Between the
Two Wall-Mounting Brackets)
for SMART Board 685 or
SBD685 Interactive
Whiteboards
Cable Routing for SMART
Board 560, 580, 660, 680 and
SBD680 Interactive
Whiteboards