Smart Technologies 600i3 User Manual
Page 6
iv
|
INTRODUCTION – IMPORTANT INFORMATION
•
When replacing the projector lamp:
–
Turn the projector off and wait 30 minutes for the lamp to cool completely
before removing the projector from the boom.
–
Do not remove any screws other than those specified in the lamp
replacement instructions.
–
Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.
–
Use only replacement lamps approved by SMART Technologies. Contact
for replacement parts.
–
Never replace the lamp assembly with a previously-used lamp assembly.
–
To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.
–
Recycle or dispose of the lamp module as hazardous waste,
in accordance with local regulations.
•
When returning the projector to the boom, replace all of the screws that you
removed when you removed the projector. Failure to do so can result in the
projector falling from the boom, causing injury or equipment damage.
•
To reduce the risk associated with a leaking battery in your projector’s remote
control:
–
Use only the specified coin-cell type battery.
–
Orient the battery’s plus (+) and minus (-) terminal according
to the markings on the remote control.
–
Remove the battery when the remote control is unused for an extended
period.
–
Do not heat, disassemble, short or recharge the battery, or expose it to
fire or high temperatures.
–
Avoid eye and skin contact if the battery has a leak.
–
Dispose of the exhausted battery and product components in accordance
with applicable regulations.