Smart Technologies 600i3 - Manual (Page 43)

31 | CHAPTER 4 – USING YOUR SMART BOARD 600I3 OR SBD600I3 INTERACTIVE
WHITEBOARD SYSTEM
Using Your UF55/UF55w Projector
The UF55/UF55w projector includes two LED indicators. Refer to the Power and
Temperature status indicators on the projector’s underside to determine the projector
status and to troubleshoot unexpected behavior.
Using Your Remote Control
The UF55/UF55w projector system remote control enables you to open on-screen
projector menus and change the projector settings. You can also use the remote
control’s ON/IDLE
button or the ECP power button to turn the projector system on
or off.
NOTE
Ensure that you remove the remote control battery’s plastic casing before use.
You can access the adjustment options through the remote control’s Menu button.
To adjust settings using
the remote control
1. Press the left or right button to access a menu option.
2. Press the up or down button to select the relevant menu option.
3. Press the left or right button to move between menu option settings.
4. Press enter when you’re satisfied with the settings.
Menu Options
NOTE
The menu heading at the top of all settings is SMART UF55 Settings.
Menu
Heading
Settings Description
Image
Adjustment Display
Mode Adjusts the display output to sRGB, Bright Room,
Dark Room, User, and SMART Presentation.
Brightness Adjusts projector brightness from 0 to 100.
Contrast Adjusts projector contrast from 0 to 100.
Frequency Adjusts the frequency of the projected image from -5
to 5. Default is set to 0. Applies to the VGA inputs
only.
Tracking Synchronizes your display timing with your
computer’s graphic card from 0 to 31. Applies to the
VGA inputs only.