Smart Technologies 600i3 - Manual (Page 8)

vi | INTRODUCTION – IMPORTANT INFORMATION
IMPORTANT
•
Use the instructions that are in the UF55/UF55w projector boxes to install
your system. Do not use the instructions in your SMART Board interactive
whiteboard product box.
• Do not set up or use your interactive whiteboard system in an area
with excessive levels of dust, dirt, humidity or smoke.
• Do not place your interactive whiteboard system near any appliance that
generates a strong magnetic field.
• Do not place your interactive whiteboard system in direct sunlight.
• The screws that secure your interactive whiteboard to the wall are located
directly behind the pen tray. The pen tray must be removed before you can
remove your interactive whiteboard. When you secure the pen tray, you also
secure your interactive whiteboard.
• Using the UF55/UF55w projector system near a TV or radio may cause
interference to the images or sound. If this happens, move the TV or radio
away from the projector.
• Your SMART Board 600i3 or SBD600i3 interactive whiteboard system does
not include speakers. To play audio, connect an audio system to the
projector’s audio output. Consult your
authorized SMART reseller
to determine your audio output options.
• If you have peripheral devices that do not use a 4-pin mini-DIN connector or
an RCA composite video jack, or if your device has an audio connection that
does not use RCA jacks, you may need to purchase third-party adapters.
• When cleaning your interactive whiteboard system:
– Wipe the exterior of the projector using a lint-free cloth.
– If necessary, use a soft cloth moistened with a mild detergent to clean the
projector housing.
– Do not use abrasive cleaners, waxes or solvents.
• Disconnect the product from its power source when it’s not used for a
long period.
• If your interactive whiteboard system requires replacement parts, make sure
that the service technician uses replacement parts specified by SMART
Technologies, or parts with the same characteristics as the original.