SnapGear 1.7.8 - Manual (Page 32)

If you are using Windows 2000, click Start, Settings, Network and Dial-up
Connections, right-click Local Area Connection, click Properties, select Internet
Protocol and then click Properties to display the following screen:
Figure 2.3 TCP/IP properties
You can also manually configure the PCs on your network. For each non-configured
Windows 2000 PC on the network, open TCP/IP Properties using the above instructions
and ensure that Use the following IP address is checked and add the following
information:
• A unique IP address and appropriate subnet mask.
• The Default Gateway (enter the IP address of the SnapGear appliance).
• In the DNS tab, enter the DNS server address(es) provided by your ISP, or the
address of the SnapGear appliance if you are using the DNS proxy.
Getting started
29