SnapGear 1.7.8 - Manual (Page 49)

An icon is displayed in Dial-Up Networking with your Connection Name. Right click the
icon once, and then click File and Properties and click the Server Types tab as shown
in the following figure:
Figure 4.6 Server types
Check the Log on to network and Enable software compression checkboxes. If your
SnapGear appliance dial-in server requires MSCHAP-2 authentication, you also need to
check the Require encrypted password checkbox. Leave all other Advanced Options
unchecked.
Select the TCP/IP network protocols from the Allowed network protocols list.
Warning
Do not select NetBEUI or IPX. If an unsupported protocol is selected, an error message
is returned when attempting to connect.
Click TCP/IP Settings and confirm that the Server Assigned IP Address, Server
Assigned Name, Server Address, Use IP Header Compression and Use Default
Gateway on Remote Network are all checked and click OK.
Dial-in server configuration
46