SnapGear 1.7.8 - Manual (Page 54)

5. Network configuration
IP configuration
Users can set the IP address configuration for both the LAN and Internet interfaces by
selecting IP Configuration from the Networking menu as shown in the following figure:
Figure 5.1 IP configuration
To configure the LAN Interface of the SnapGear appliance, select either a dynamically or
statically assigned IP address. If the LAN interface of your SnapGear appliance gets its
IP address from a DHCP server on your local network, then check DHCP assigned.
For a static IP address on the LAN interface, enter the IP Address and Netmask in the
fields provided. You must enter a static IP address if the SnapGear appliance will act as
the DHCP server on your local network.
Network configuration
51