SnapGear 1.7.8 - Manual (Page 48)

Remote user configuration
Remote users can dial-in using the SnapGear appliance using the standard Windows
Dial-Up Networking software. Set up a new dial-out connection on the remote PC to dial
the phone number of the modem connected to the SnapGear appliance COM port. After
the dial-in is connected, users can access all network resources as if they were a local
user.
For Windows 95 and Windows 98:
From the Dial-Up Networking folder, double-click Make New Connection and enter the
Connection Name for your new dial-in connection as shown in the following figure:
Figure 4.5 Make new connection screen
Select the modem to use from the Select a device pull down menu.
Click Next and enter the phone number of the modem connected to the SnapGear
appliance.
Click Finish.
Dial-in server configuration
45