SnapGear 1.7.8 - Manual (Page 98)

Appendix A – LED status patterns
The following table shows the different LED illumination combinations that can indicate
possible error conditions.
In each case, the LEDs indicated will be on and steady, unless otherwise noted, and all
other LEDs will be off. The Power and System LEDs are not part of the LEDs indicating
status. Where the action indicates that you should contact your dealer, please note the
LED pattern to assist with faster response and recovery action.
LED Pattern Status Action
VPN Memory failure. Please contact your
dealer.
COM2 Console device cannot initialize. Please contact your
dealer.
All LEDs on In recovery mode, usually from a bad Flash
image. While the reset button is held in this
will be the LED pattern.
VPN &and Internet
Link Cannot load static data into memory,
probably memory and/or Flash problem. Please contact your
dealer.
COM2 and Internet
Link Cannot load SBSS, probably memory and/or
Flash problem. Please contact your
dealer.
Online Memory exception. Please contact your
dealer.
Appendix A – LED status patterns
95