Socket Mobile GFK0121E - Manual (Page 17)

2
2-7 GFK-0121E Chapter 2 Hardware Setup
HHM Installation Instructions
1. Select a suitable location for the HHM. Environmental specifications are listed on
page 1-5. The location must have 115 VAC or 230 VAC power.
2. Cut an opening 3.75
I
(9.53cm) wide x 8
I
(20.32cm) high in the panel. Drill four
mounting holes as shown below.
6.00in
(15.24cm)
1.00in (2.54cm)
1.00in (2.54cm)
3.75in
(9.53cm)
4.38in
(11.13cm)
Cutout
3. Attach the bracket to the HHM with the screws, washers, and lockwashers provided.
(4) holes for
mounting on
panel
(2) holes for mounting to
back of Hand-held Monitor
4. Using appropriate hardware (not provided), mount the HHM and bracket in the
cutout.
5. Connect the power cord to the HHM, and connect the signal cable to the connector.