Socket Mobile GFK0121E - Manual (Page 25)

3
3-5 GFK-0121E
Chapter 3 Getting Started
Changing the HHM Display Language
The next display shows the current language
selection.
H H M C O N F I G
L A N G U A G E
E N G L I S H
t g l e n t r n x t
Press F2 (TGL) to change the display language
(French, German, Italian, English). Press F3
(Enter) to save the change.
Selecting the Host CPU
The next display shows the Hand-held Monitor’s
host CPU selection. The choices are: Series Six,
Series Five, PCIM/QBIM/GENI, or Series 90.
S E L E C T H O S T C P U
S E R I E S S I X
To change the host CPU type, press the F2 (TGL)
key, then press F3 (Enter).
Enabling/Disabling Automatic Shutoff
The next screen shows whether automatic shutoff
is selected.
A U T O O F F = 1 O m i n
E N A B L E D
This feature conserves battery power by shutting
off the Hand-held Monitor 10 minutes after the
last key press. To change the current selection,
press F2 (Toggle), then F3 (Enter).
Enabling/Disabling the Ability to Change Block
ID Parameters
The next display shows whether the Hand-held
Monitor is able to configure the Block Number
(serial bus address) of bus devices, as well as the
I/O circuit mix of some types of I/O blocks.
C H N G B L K I D
E N A B L E D
This selection also determines whether the HHM
is able to assign the Reference Address of I/O
blocks, or change the I/O mapping of a Remote
I/O Scanner (for the modules in its remote drop).
To enable or disable this capability, press F2 (TLG),
then F3 (Enter).