Socket Mobile GFK0121E - Manual (Page 19)

2
2-9 GFK-0121E Chapter 2 Hardware Setup
Installing a Separate Hand-held Monitor Connector
You can add a connector to the bus for a permanently-mounted Hand-held Monitor, or
to provide an additional attachment point for a portable HHM.
The unit shown below (catalog number 44A736310-001-R001) provides a Hand-held
Monitor connector and serial bus terminals.
Hand-held Monitor
Connector
Serial Bus Terminals
Panel Mounting Ear
2.834 in
7.198 cm
1.673 in
4.249cm
.5 in
1.27 cm
shown at 100% of actual size
X1
X1 X2
X2 SA SB
SA SB
X1 Serial 1
X2 Serial 2
SA Shield In
SB Shield Out
46357
Mounting the HHM Connector
This unit can be easily mounted on a rail such as a standard 35mm (shown below) or
15mm DIN rail. The panel-mounting ears are not used if the unit is installed on a DIN
rail.
35mm DIN rail
(Removable) DIN rail
Mounting Feet
side view: shown at 50% of actual size
46358
Alternatively, it can be installed directly on a panel using screws through its mounting
ears. The DIN rail feet on the back of the unit are removed when the unit is
panel-mounted.