Socket Mobile GFK0121E - Manual (Page 24)

3
3-4 GFK-0121E Hand-held Monitor User’s Guide – June 1994
Configuring the Hand-held Monitor
You can change the following operating
characteristics of the Hand-held Monitor:
H PLC reference format.
H 153.6 Kbaud “standard” baud rate.
H Device Number set to 0.
H English language displays.
H Shutdown after 10 minutes of inactivity.
H I/O block configuration enabled.
H I/O circuit forcing enabled.
H Fault clearing enabled.
Select F1 (HHM Utilities) from the Home menu to
access the HHM Utilities menu:
F 1 : H H M C O N F I G
F 2 : H H M S E L F T E S T
F 3 : H E L P
F 4
To change the configuration of the Hand-held
Monitor, select F1 (HHM Config) from the HHM
Utilities menu.
Note
The HHM key must be in the key-
switch, turned to CFG position.
After setting up the configuration, you can prevent
changes by turning the keyswitch to the MON
position and removing the key.
Changing the HHM Device Number
The Device Number (serial bus address) assigned
to the Hand-held Monitor appears on line 2 of the
first HHM configuration screen.
H H M C O N F I G
B L O C K N O . O
c h n g n x t
Each device on a Genius bus must have a unique
serial bus address number. A new HHM has
number 0. If multiple HHMs will be used on the
same bus, each of them must be assigned a
different Device Number.
If you want to change the HHM Device Number,
follow these steps:
H Press the ON key. Go to the Home menu. Se-
lect F1 (HHM Utilities), then F1 (HHM Config).
H From the HHM Configure menu, press F2
(Change) to clear the existing Device Number.
Enter the new number and press F3 (Enter).
Pressing F4 from the buad rate screen will advance
you through additional HHM configuration
screens. Press Home if you want to return to the
Home menu, or use the
D Menu key to go back to
the previous screen.