Socket Mobile GFK0121E - Manual (Page 31)

4
4-4 GFK-0121E Hand-held Monitor User’s Guide – June 1994
Completing the Program Block ID Screens
Select F1 (Program Block ID) from the
Configuration menu to complete the mandatory
part of a device’s configuration. (The HHM’s
CHNG BLK ID capability must be enabled).
When the HHM is set up for a PLC host, the
Program Block ID screen looks like this:
P R O G B L O C K I D
I / O (device references)
B L O C K N O . (device #)
r e f b l k n x t
If there are ? symbols on the screen, the
reference address and/or Device Number have not
yet been configured. If there are * symbols on the
screen, a reference address was previously
assigned, but is out of range for the host CPU
currently set up for the HHM. If this happens,
check the host CPU setup in the HHM Utilities.
When the HHM is set up for a PCIM/QBIM/GENI
host, references are not used. Instead, the second
line describes the device:
P R O G B L O C K I D
I S O L 8 (device #)
B L O C K N O . (device #)
r e f b l k n x t
To Enter or Change the Device Number: the
Hand-held Monitor must be connected directly to
the device.
1. Press F2 (blk). Then, enter the intended num-
ber (1-30). If you make a mistake, press F2
twice again, then enter the correct number.
2. Press the F3 (Enter) key. If the device is on-line
and the number has already been used, an er-
ror message appears.
To Complete the Program Block ID Screen: The
Program Block ID screen is used to configure
additional features for some devices. These vary
from device to device; you should refer to the
device’s User’s Manual if you need more
information.
To Change the Device’s Baud Rate: press F4
(Next) from the Program Block ID screen. (The
HHM’s CHNG BLK BAUD capability must be
enabled).
S E L E C T B A U D R A T E
A C T I V E = 1 5 3 . 6 K S T
P R O G = 1 5 3 . 6 K S T
t g l e n t r n x t
The bus will not operate unless all devices are set for the
same baud rate. Check the baud rate before
introducing blocks onto an operating bus.
H To change the device’s baud rate, press F2
(Toggle), then press F3 (Enter).
H Cycle power to all devices on the bus at the
same time to use the new baud rate.
To Set the I/O Map for a Remote I/O Scanner:
The next screen is used to assign data types and
lengths for a Series 90-70 Remote I/O Scanner. See
the next page.