Sony RM-VL1000T - Manual (Page 15)

15
When the desired component
is selected, the component
name (in this case, TV), and the
four-digit component code
number previously set for the
component are displayed.
5
Press the four-digit
component code number by
pressing the number
buttons followed by the
ENT button.
Example: To enter “8086”
Input “8,” “0,” “8,” “6,” and
press the ENT button.
If the setting of the code is
successful
With a beep sound, “OK” and
input digits are displayed.
The digits are decided and the
display returns to the
presetting mode.
If you press the SET button
The display returns to the setting
mode.
If you press the SET button
again
The display for component
operation appears.
Continued
COMPO
SET
PRESET
8001
TV
6
If you want to set a code for
another component, repeat
Steps 4 and 5.
If you press the SET button
The display returns to the previous
one.
Notes
• If you press a component code
number that is not on the table in the
supplied “Component Code
Numbers,” the Commander beeps
five times and “NG” flashes after you
press the ENT button. The setting
returns to the previous one. If this
happens, check the component code
number, and try setting again.
• If you don't input anything into the
Commander for over two minutes
between each step, the setup
procedure will be cancelled. In this
case, preset again.
• The first digit of the component code
number means the component
category (TV, VCR, etc.). The
component corresponding to the
four-digit component code number is
preset in Step 5. If you preset the
component of which the category is
different from that preset previously,
you can, if necessary, change the
component names (see page 65).
• If you preset a component code after
you input character contents to the
labels on the LCD display (page 65),
they are cleared and the original
display is shown. Edit the characters
after you decide the component to be
used by presetting a code.