Sony RM-VL1000T - Manual (Page 41)

41
1
In Step 4 (page 35), select
“COMPO” by pressing the
Label Select button.
Component names are
displayed. The labels for which
a series of commands is
programmed stay lit and others
flash.
2
Select the component for
which you want to
programme a series of
commands by pressing the
Label Select button (for
example, DVD).
3
Programme a series of
commands for the
component label by
following the same
procedure of Step 6-8 on
page 36.
SYSTEM COMPO
SET
SYSTEM
TV
SAT1
VCR1
DVD
SYSTEM
SET
SYSTEM
COMPO
Continued
4
Press the SET button.
With a beep sound, a series of
operating commands is
registered.
The display returns to Step 2
above.
To clear the component macro
of a label
In Step 2 (page 41), while pressing
the Label Select button
corresponding to the label that
you want to erase, press the
SCROLL button. (The labels for
which a series of commands is
programmed stay lit.)
“CLEAR OK” appears and the
component macro is cleared with a
beep sound.
The cleared label flashes together
with other labels for which a series
of commands is not programmed.
Note
When you select the label for which a
series of commands is programmed,
the ‘NG’ sound is heard. If you release
the Label Select button then, data is not
cleared and the component macro
signal is transmitted.