Sony RM-VL1000T - Manual (Page 55)

55
Continued
Notes
• When using the timer setting on this
Commander, only one setting can be
assigned to one programme. If you
want to set the timer to turn on at a
programmed time, and to set the
timer to turn off at another time,
programme the two settings
separately.
• If there are some programmes set to
be executed at the same time, they
start in order from the lowest
programme number.
• According to the status of the
component operated by the timer
programme, the next programme
might not function successfully.
When setting a timer programme,
check carefully the setting of other
programmes.
• Some programmes cannot be
executed at the set time because the
execution time of the remote control
output is different depending on the
contents of the timer execution. Or, if
the execution time arrives while the
previous timer programme is
outputted, the timer programme
begins after the execution of the
previous one. In this case also, the
programme cannot be executed at the
set time. So, set the timer regarding
the contents and the duration of the
timer execution.
12
Repeat Steps 10 and 11.
When 32 steps are input, the
Macro step programming
registered with a beep sound.
Then the display returns to
step 6.
Notes
• You can input up to 32 steps for one
timer programme number.
• A System Macro can be input as a
step.
• You can change the interval between
operation steps (page 42).
• The step of the TIMER button has an
interval of 250ms. This operation of
programming an interval is counted
also as a step.
• The SCROLL button is not counted as
a step.
13
When you have
programmed a series of
Timer Macro setting, press
the SET button.
With a beep sound, a series of
Timer Macro settings are
registered.
The display returns to Step 6.
Each time you press the SET
button, the display returns to
the previous one.
If you want to check the
execution of the timer
setting or set the timer
programme to the standby
mode
See page 58.