Stinger JPEG 2000 User Manual
Page 27
Setup
5-4. Record Setup
This is the most important configuration of the DVR.
Enter into SYSTEM MENU-RECORD SETUP and press the
[ENTER] button.
5.4.1 Record Configuration
Use direction button to move and [-] [+] button to set value.
1. OVERWRITE: Set overwrite or stop recording when the HDD is full.
2. MULTIPLEX: DUPLEX: Playback & Ethernet
TRIPLEX: Playback & Recording & Ethernet
Note: DUPLEX MODE is recommended to playback the images at a maximum frame rate. But,
one down side is that it causes the DVR not to record during a playback/search.
3. QUALITY: Setting recorded picture quality.
To select the picture quality, the user will step-through the quality settings as listed below. Be aware
the higher the resolution (eg: Super Fine), the quicker the HDD capacity will be used up and images
will be overwritten earlier. For most operations we recommend either
BASIC or NORMAL.
BASIC -> NORMAL -> ENHANCED -> FINE -> SUPER FINE: Default quality set by manufacturer is Super Fine
In Emergency recording mode, recording quality is SUPER FINE.
To send more images via IP network and longer recording time, set QUALITY at NORNAL or
ENHANCED and record at 360x240 or 360x120.
Data size of image in PAL system is a little bigger than NTSC system, but the total recording time is same as in
NTSC system.