SLS Audio NEEK Board Support Package uClinux - Manual (Page 51)

uClinux NEEK BSP Debugging Kernel and User Applications
8. Project types, executable, Hello world ANSI C Project, (or empty project
and add your source).Finish.
9. Now, setup for nios2 tool chain in Eclipse IDE on the host by following
the steps below:
a) Select the project Helloworld under Project Explorer.
b) Right click on Helloworld and select Properties. Project properties
dialog box opens.
• Select Settings>GCC C Compiler under C/C++ build. Make
following settings:
• Command: nios2-linux-uclibc-gcc
• All options: -O0 -g -Wall -c -fmessage-length=0
• Click Apply.
• Select Settings>GCC C Linker under C/C++ build and make
following settings
• Command: nios2-linux-uclibc-gcc
• All Options: -elf2flt
• Select Miscellaneous under GCC C Linker
• Linker flags: -elf2flt
• Click Apply
c) Select Run/Debug Settings under Project properties. Run/Debug
settings dialog box opens
• Click on New button. Select Configuration Type dialog box
opens
• Select C/C++ Local application.
• Click OK. Properties for new Configuration dialog box opens.
• Under Main tab do the following settings:
• Browse the Helloworld project under project.
• Type Debug/Helloworld.gdb
• Select Debugger tab. Make following settings
• Debugger: gdbserver Debugger
• Under Main tab of Debugger options make following settings
• GDB Debugger: nios2-linux-uclibc-gdb
• Under Connection tab
• Type: TCP
• Host name or IP address: 192.168.0.14 (IP address of
NEEK board)
• Port Number: 9999 (you can give any number)
• Click Apply and click OK. You have finished setting of
run/debug settings.
• Click Apply and click OK. This finishes project properties
settings.
d) Select Project>Build Configuration>Build>All to build your project.
System Level Solutions 43