Sony PDW-V1 - Manual (Page 50)

Cha
p
te
r 5
Sc
en
e Sele
c
tion
50
5-2 Basic Operations
1
Carry out steps 1 to 4 in the procedure, “Moving a sub
clip” above.
2
Use the arrow buttons to select TRIM, and press the
SET button.
The first frame of the selected sub clip appears in a
full-screen display. In this state, you can carry out
playback and search within the clip including the
selected sub clip.
To cancel the trim and escape from the sub clip
trim screen
Hold down the SHIFT button and press the SET
button.
3
Carry out playback and search to find the new location
of the IN point or OUT point of the selected sub clip.
4
At the point where you want to set the new IN point or
OUT point, hold down the
G/IN button (when
changing the IN point) or the g/OUT button (when
changing the OUT point), and press the SET button.
Depending on which button you pressed, this sets the
IN point or OUT point, and the IN indicator or OUT
indicator lights.
To change both the IN point and the OUT point,
repeat steps 3 and 4.
To reset the IN point or OUT point, hold down the
G/IN button or the g/OUT button and press the
RESET button.
The IN point and the OUT point return to the state
before the sub clip trimming screen was displayed.
To cue up the IN point or OUT point, hold down the
the
G/IN button or the g/OUT button and prees the
PREV or NEXT button.
Note
You can press the THUMBNAIL button to return to
full-screen sub clip display, without trimming a sub
clip.
5
When the new IN and/or OUT points are set, hold
down the SHIFT button and press the SET button.
This carries out the trimming, and the screen returns to
the sub clip thumbnail display.
To cancel the trim operation
Reset the IN point and the OUT point to return to the
state before the sub clip trimming screen was
displayed, then hold down the SHIFT button and press
the SET button.
Deleting a sub clip
Proceed as follows.
1
Carry out steps 1 to 4 in the procedure, “Moving a sub
clip” (page 48)
2
Use the arrow buttons to select DELETE, and press the
SET button.
The sub clip deletion screen appears.
To cancel the deletion, and escape from the sub clip
deletion screen
Do either of the following.
• Use the left or right arrow button to select CANCEL,
and press the SET button.
• Press the RESET button.
The screen returns to the sub clip thumbnail display.
3
Use the left or right arrow button to select OK, and
press the SET button.