Sony PDW-V1 - Manual (Page 88)

Chap
ter
8
Maint
ena
nc
e and
T
roub
les
h
o
o
ting
88
8-3 Alarms
When the unit is powered on
a) With respect to setting of basic menu item 016
When a disc is inserted
Message in time
data display Display
condition
a)
Description Action
MENU Ver.UP off Setup menu settings were reset,
because this unit was upgraded. Reset the setup menu items.
See 7-2-2 “Basic Menu Operations”
(page 69) and 7-3-2 “Extended Menu
Operatoins” (page 75) for information
about making setup menu settings.
Maintenance menu item “SETUP
MAINTENANCE” - “SAVE MENU
DATA/LOAD MENU DATA” (see page
80) can be used to temporarily back up
and restore the current menu settings.
ILL. SETUP! off Setup menu data is invalid, or data
recalled with the maintenance menu item
“SETUP MAINTENANCE” - “AUTO
BANK RECALL” is invalid. Reset the items in the setup menu.
Exchg batt! off NVRAM battery is exhausted. It is time to exchange the battery on the
board. Contact your Sony service
representative.
LOW BATT! off Battery pack power is low. Exchange with a charged battery pack.
See 3-2-2 “Using a Battery Pack” (page
33) for more information about
exchanging battery packs.
BATT EMPTY! off Battery pack power is exhausted.
Message in time
data display Display
condition
a)
Description Action
Unknown FS! off The loaded disc was formatted by an
unknown file system. Eject or format the disc.
See 3-6-5 “Formatting a Disc” (page 37)
for more information about formatting.
No FS! off The file system cannot be detected. Eject the disc.
ILL. Disc! off An unsupported disc was inserted.
Salvage NG off Recovery of disc contents (salvage)
failed. See 3-6-7 “Using the Salvage Function”
(page 38).
525/60 Clip limit A disc recorded in NTSC format was
inserted when this unit is in 625 line
mode (PAL system). Use a disc recorded with the PAL
system.
625/50 Clip limit A disc recorded in PAL format was
inserted when this unit is in 525(U) or
525(J) line mode (NTSC system). Use a disc recorded with the NTSC
system.
IMX50 Clip
IMX40 Clip
IMX30 Clip
DVCAM Clip limit The recording format of the loaded disc
differs from the format specified with
basic menu item 031 “RECORDING
FORMAT.” To record on the disc, change the setting
of basic menu item 031.
See 7-2-2 “Basic Menu Operations”
(page 69) about how to change this
setting.
4CHx/24 Clip
8CHx16 Clip limit The number of channels and quantizing
bits of the loaded disc differ from the
specifications of maintenance menu item
“AUDIO CONFIG” - “DATA LENGTH.” To record on the disc, change the setting
of maintenance menu item “AUDIO
CONFIG” - “DATA LENGTH.”
See 7-4-2 “Maintenance Menu
Operations” (page 81) about how to
change this setting.