2 specifying f codes, When sending faxes, Programming f codes – Konica Minolta bizhub 160f User Manual
Page 163
Fax transmission/Reception methods
6
bizhub 160f
6-29
6.3.2
Specifying F codes
When sending faxes
F codes can be specified when the 10-key pad is being used to enter the fax
number of a recipient while sending a fax.
1
Using the 10-key pad, enter the fax
number of the recipient.
2
Press the [,] key, and then use the
10-key pad to enter the SUB.
–
A number up to 20 digits long can
be entered for the SUB.
–
To enter an SID, continue with step 3.
–
If an SID will not be entered, continue with step 4.
3
Press the [,] key, and then use the
10-key pad to enter the SID.
–
A number up to 20 digits long can
be entered for the SID.
4
Press the [Start] key to begin scanning and sending the fax.
Programming F codes
F codes can be specified when programming one-touch dial keys or speed
dial numbers.
!
Detail
For details, refer to “Fax registration settings” on page 7-26.