KTM 690 ENDURO EU - Manual (Page 106)

MAINTENANCE WORK ON CHASSIS AND ENGINE
104
100277-10
– Disconnect the negative (minus) cable of the battery.
– Pull off connector
 in an upward direction.
– Remove screws  .
– Pull retaining bracket  of the battery forward and remove it.
– Take off the positive terminal cover  .
– Disconnect the positive (plus) cable of the battery.
– Press the wiring harness to one side and pull the battery out of the battery rack.
Info
Never operate the motorcycle with a discharged battery or without a battery. In
both cases, electrical components can safety equipment can be damaged. The
vehicle is then no longer safe to ride.
9.51
Installing the battery x
100277-11
– Slide the battery into the battery rack.
Info
The battery terminals must be at the rear.
– Attach the positive cable and mount positive terminal cover  .
– Position retaining bracket  .
– Mount and tighten screws  .
Specification
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Plug in connector  .
– Attach the minus cable .
– Mount the seat. (
P. 103)