KTM 690 ENDURO EU - Manual (Page 50)

RIDING INSTRUCTIONS
48
– For example, if the engine stalls at a junction, just pull the clutch and press the electric
starter button. You do not need to shift into neutral.
– Switch off the engine if you expect to be standing for a long time.
– Avoid frequent and longer slipping of the clutch. This heats the engine oil, the engine
and the cooling system.
– Ride with a lower engine speed instead of with a high engine speed and a slipping
clutch.
– If the FI warning lamp (MIL) starts to light up during the journey, stop immediately. If
you shift to neutral, the FI warning lamp (MIL) begins to flash.
Info
From the flash rhythm, you can deduce a two-digit number, the so-called flash
code. The flash code tells you which component is affected by a fault.
7.5
Braking
Warning
Danger of accidents If you brake too hard, the wheels can lock.
– Adapt your braking to the traffic situation and the road conditions.
Warning
Danger of accidents Reduced braking due to wet or dirty brakes.
– Clean or dry dirty or wet brakes by riding and braking gently.
Warning
Danger of accidents Reduced braking caused by spongy pressure point of front or rear brake.
– Have the brake system checked in an authorized KTM workshop, and do not ride any further.