Combination instrument - odo display, Operating elements – KTM 690 ENDURO EU User Manual
Page 32
OPERATING ELEMENTS
30
700115-10
– Switch on the ignition by turning the ignition key in the position .
– Press the MODE button several times until the ODO display mode is active.
– Keep the MODE button and the SET button pressed simultaneously.
The time begins to flash.
– Press the MODE button to adjust the hour.
– Press the SET button to adjust the minute.
– Keep the MODE button and the SET button pressed simultaneously.
The time is set.
5.22
Combination instrument - ODO display
700120-01
In
ODO mode, the total distance covered is shown in kilometers or miles.
Info
This value remains intact even if the battery is disconnected and/or the fuse blows.
5.23
Combination instrument - setting/resetting TRIP 1 display
Info
The tripmaster
TRIP 1 operates constantly and counts up to 999.9.
You can use the tripmaster to measure trips or the distance between refuelling stops. After reaching
999.9, the tripmaster begins
again at
0.0.