Kodak RP 50 2J0686 - Manual (Page 153)

Additional Calibration Information
October 2002 C-19
MACINTOSH Version
3. Enter the desired settings and click OK to save the settings (or Cancel to
keep the previous settings).
The selected test target is sent to the printer.
Editing the Calibration Configuration
The Edit Configuration feature allows you to change the printer’s calibration
configuration attributes. However, it is recommended that you use the default
settings for these attributes for most operations. The settings should only be
changed for the most advanced operations.
Edit Configuration consists of a set of six tabbed screens—each with related
configuration attributes. There can be only one set of configuration attributes for
the printer calibration application at a time. If you make any changes to one or
more of the tabbed screens and then click OK to save your changes, the changes
will overwrite the previous attributes used for the automated calibration.
To edit the calibration configuration:
1. From the KODAK Device Calibration screen, double-click the device for which
you want to change the calibration configuration.