Kohler COMMAND CH18-745 - Manual (Page 206)

11.21
Section 11
Reassembly
11
Figure 11-74. Reinstalled Fuel Pump.
Install Carburetor
WARNING: Explosive Fuel!
Gasoline may be present in the carburetor and fuel
system. Gasoline is extremely flammable and its
vapors can explode if ignited. Keep sparks and other
sources of ignition away from the engine.
1. Install a new carburetor gasket. Make sure all
holes align and are open.
2. Install the carburetor, throttle linkage and
governor lever as an assembly. See Figure 11-75.
If a plastic intake manifold is used and the
carburetor is equipped with a fuel solenoid, attach
the ground lead to the carburetor mounting screw.
See Figure 11-76.
Figure 11-77. Install Governor Lever to Shaft.
Metal-Cased Pulse Fuel Pump
Plastic-Cased Pulse Fuel Pump
Figure 11-76. Ground Lead on Carburetor Mounting
Screw.
3. Torque the two carburetor mounting screws to
6.2-7.3 N·m (55-65 in. lb.).
Install External Governor Controls
1. Install the governor lever onto the governor cross
shaft. See Figure 11-77.
Figure 11-75. Installing Carburetor Assembly.