Kohler COMMAND CH18-745 - Manual (Page 45)

5.12
Section 5
Fuel System and Governor
Figure 5-13. Electronic Governor Assembly.
Digital Linear Actuator (DLA)
Energizing the bi-directional digital linear actuator coils
in the proper sequence, causes the threaded shaft to
move out of, or back into the rotor, in precise linear
increments. When power is removed, the actuator
shaft remains in position. The DLA must initialize (fully
extend) to move the throttle plate to the closed
position, and partially open for starting. Correct
adjustment of the DLA is critical to achieve the full
range of throttle plate movement. See Adjustment
Procedure.
Figure 5-11. Governor Control Connections.
Electronic Governor
General
The electronic governor regulates engine speed at
varying loads. It consists of a governor control unit,
digital linear actuator and linkage.
Choke Control Cable
Throttle
Control
Cable
Kill Switch
Choke Control Lever #1
Throttle Control Lever #2
Choke Linkage
Z Bend
Throttle Control Cable
Choke
Control
Cable
Right Side Pull
High Speed
Control Lever
High Speed
Adjusting
Screw
Dual Control High
Speed Lever Stop Screw
"Do Not Remove"
Kill Switch Adjusting Screw
Left Side Pull
Figure 5-12. Electronic Governor Assembly.
1. Digital Linear Actuator
2. Throttle Linkage
3. Linkage Spring
4. Choke Linkage
5. Throttle Lever Adapter
1
2
3 4
5
Governor Control Unit