Kohler COMMAND CH18-745 - Manual (Page 212)

11.27
Section 11
Reassembly
11
Figure 11-87. Connecting Fuel Inlet Line.
2. Position a new gasket and the air cleaner base
while carefully pulling the loose end of the rubber
breather hose through the base until properly
seated (collars sealed against each side of base).
See Figure 11-88.
Figure 11-88. Pulling Breather Hose through Base.
NOTE: Route the fuel line in the contour, as
shown in Figure 11-89, to avoid
restriction.
3. Secure the air cleaner base and bracket using the
hex. flange screws. Position the bracket with the
hole toward the breather hose. Be careful not to
drop screws into the carburetor. If a rear air
cleaner bracket is used, install the two M5 screws
through the rear of the base. Torque the three M6
screws to 6.2-7.3 N·m (55-65 in. lb.) and the two
rear M5 mounting screws (when applicable) to
4.0 N·m (35 in. lb.). See Figures 11-90 and 11-91.
Figure 11-89. Fuel Inlet Line Detail.
Figure 11-90. Torquing Base Screws.
Figure 11-91. Tightening Rear Base/Bracket Screws
(Some Models).
4. Install the breather hose in the hole in the bracket.
5. Install the air cleaner components as described in
Section 4.
Install Muffler
1. Install the port liners (if equipped). Install the
muffler and attaching hardware to the muffler
bracket. Torque screws to 9.9 N·m (88 in. lb.).
2. Install the hex. flange nuts to the exhaust studs.
Torque hex. flange nuts to 24.4. N·m (216 in. lb.).