KORG TRITON STUDIO V2 - Manual (Page 68)

63
Disk
Global
Sampling
Combination
Program
Other functionality
Combination mode
An “Auto Sampling Setup” page menu command has been
added to the Combination P0: Sampling page.
0–5E: Auto Sampling Setup
This convenient command automatically sets sampling-
related parameters of Combination mode to the optimal set-
tings for specific operations. (For the automatically-set
parameters and their values,
☞p.65)
When you execute this command, the applicable
parameters will be set automatically. You cannot use the
[COMPARE] key to recall the previous settings.
The settings are automatically made for the most typi-
cal applications. After executing the auto setup opera-
tion, you can further adjust any of the settings to suit
your needs as described in the
paragraphs of each
section.
1. Initialize
This sets sampling-related parameters to their default state.
1 Select “Auto Sampling Setup” to open the dialog box.
2 Use the radio buttons to select Initialize.
3 Press the OK button to execute “Auto Sampling Setup.”
If you decide to cancel, press the Cancel button. (For the
automatically-set parameters and their values,
☞p.65)
2. Resample Combination Play
This automatically makes the appropriate settings so you
can play a combination and resample your performance.
■ Setup
1 Select “Auto Sampling Setup” to open the dialog box.
2 Use the radio buttons to select Resample Combination
Play
.
3 Use “Save to” to specify the destination to which the res-
ampled data will be written. (
☞PG p.5 “Save to”)
RAM: The resampled data will be written into sample
memory (RAM). If the “Convert to Program” option in
step
4 is checked, a new multisample will automatically
be created after resampling.
DISK:
A WAVE file will be created for the resampled
data and saved on the internal hard drive or an external
SCSI hard drive.
4 If you selected “Save to: RAM,” checking “Convert to
Program”
will convert the resampled data into a pro-
gram using the number you specify in “Program.” You
can then move to Program mode after resampling and
play the data immediately.
5 Use “Program” to specify the program where the con-
verted data will be saved.
6 Press the OK button to execute “Auto Sampling Setup.”
If you decide not to execute, press the Cancel button.
(For the automatically-set parameters and their values,
☞p.65. For examples of using the automatically-set
parameters, refer to
☞BG p.45)
If you selected “Save to: RAM” and want to change the
RAM bank, use “Select Bank & Smpl No.” (Program
0–3C
☞PG p.6) to specify the resampling-destination
sample memory (RAM).
If you selected “Save to: DISK,” use the page menu
command “Select Directory” (Program 0–3D
☞PG p.7)
to specify the save-destination for the WAVE file that
will be created by resampling.
■ Resample
7 Press the SAMPLING [REC] key and then the SAM-
PLING [START/STOP] key
.
8 Use the keyboard etc. to play the combination. Sampling
will begin at the first note-on. (
☞PG p.4)
9 When you have finished performing, press the SAM-
PLING [START/STOP] key
.
If you have selected “Save to: RAM” (Convert to Pro-
gram)
and continue resampling without changing the
settings, the successive samples will automatically be
assigned to C#2, D2, ...
Auto Sampling Setup
0–5E