Lincoln Electric COMMANDER 500 IM644-A - Manual (Page 45)

F-9 DIAGRAMS F-9
COMMANDER 500
CONNECTION DIAGRAM:
Disconnect NEGATIVE (-) BATTERY LEAD
AMPHENOL
Do not touch electrically live parts.
ELECTRODE CABLE TO WIRE FEED UNIT
14 PIN
TO WORK
before servicing. Do not operate with panels open. ELECTRODE
TO WORK
CAUTION : THE ENGINE WELDER OPERATING MANUAL.
APPLICATIONS. SEE OPERATING MANUAL. PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION.
Keep guards in place. Keep away from moving parts.
WARNING
Only qualified personnel should install,use or service this equipment.
TO LN-8 INPUT
K595 CONTROL CABLE
N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE SELECTOR SWITCH TO "WIRE WELDING CV".
CABLE PLUG
COMMANDER / LN-8 CONNECTION DIAGRAM
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
7-18-98 S23992